Comtech PST introduces solid-state RF module for communications, electronic warfare, and radar
MELVILLE, N.Y., 2 June 2014. Comtech PST Corp. in Melville, N.Y., is introducing the model BME69189-50 high-density RF power amplifier for communications, electronic warfare, and radar transmitter systems where space, cooling, and power are limited.
The gallium nitride (GaN)-based 6-18GHz RF amplifier expands on the company's integrated RF GaN power amplifier designs by increasing the RF power density.
The power electronics device offers ultra-wideband operation; high efficiency; full power across the bandwidth. The amplifier has RF power output of more than 50 Watts; 44 decibel gain at 50 Watts; RF input overdrive of +10 dBm; voltage standing wave ratio (VSWR) of 2.0:1 maximum; and DC to RF efficiency of 13 percent.
The unit has built-in test, with composite fault indication, over-current fault, and over-temperature fault. It has 7-pin combination D DC control interface, and runs on 15 Watts of power at standby.
It measures 6.13 by 3.5 by 1.5 inches, weighs 3 pounds, and operates in temperatures from -40 to 55 degrees Celsius. For more information contact Comtech PST online at www.comtechpst.com.
Related content
RF-Lambda selects TriQuint GaN for line of high-power amplifiers for aerospace and defense applications
Comtech PST hits the market with solid-state power amplifier for avionics, EW, radar, and communications uses
NuWaves Engineering showcases power amplifier modules at International Microwave Symposium 2013.
John Keller | Editor-in-Chief
John Keller is the Editor-in-Chief, Military & Aerospace Electronics Magazine--provides extensive coverage and analysis of enabling electronics and optoelectronic technologies in military, space and commercial aviation applications. John has been a member of the Military & Aerospace Electronics staff since 1989 and chief editor since 1995.
