Clapper push/pull type solenoids for door controls, valve control, introduced by Magnetic Sensor Systems
VAN NUYS, Calif. – Magnetic Sensor Systems (MSS) in Van Nuys, Calif., is introducing the S-66-100 series of 18 low-profile clapper push/pull type solenoids for door controls, valve control, fire-suppression systems, clutches, switches, and mixing equipment.
The low-profile push/pull clapper solenoids offer ampere turns (windings) adjusted to meet the specific force and duty cycle requirements of different applications.
The S-66-100 series solenoids are one inch in diameter, 0.66 inches deep, have a 0.4-inch stroke, and can operate at a variety of voltage-dependent duty cycles.
Supplied with four-inch leads, mounting is via two 4-40 UNC or M3 x 0.5 threaded studs 0.25 inches long on a 0.656-inch in-bolt circle. The pull end of the shaft features a 6-32 thread 0.50 inches long. The push end is 0.125 inches in diameter.
The device is for short strokes, pull force versus stroke between 0.10 inches and zero stroke range from 75 to 190 ounces at 10-percent duty cycle and from 8 ounces to 118 ounces at 100-percent duty cycle.
A low friction brass guide and stainless steel shaft assures long life. For more information contact Magnetic Sensor Systems online at www.magneticsensorsystems.com.
